Logo

C1637 Engine Code Repair

Meaning of C1637 engine trouble code is a kind of chassis trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

C1637 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting

If one of these reasons for C1637 code is occuring now you should check C1637 repair processes.
Now don't ask yourself; What should you do with C1637 code ?
The solution is here :

C1637 Possible Solution:

C1637 Engine

Air Conditioning Pressure Sensor (ACP) Insufficient Pressure Change Each time the A/C clutch engages, the PCM is looking for a pressure change in the refrigerant. If the change in pressure is outside of the calibration the DTC will set. A/C system mechanical failure Open ACP or VREF circuit A/C sensor damaged A/C system electrical failure A/C clutch always engaged Verify A/C system function, including refrigerant charge.

C1637 Code Meaning :

C
OBD-II Diagnostic Chassis (C) Trouble Code For Engine

1
Fuel And Air Metering

6
Fuel Composition Sensor Circuit Malfunction

3
Turbocharger Boost Sensor A Circuit Low

7
Ignition Coil A Primary/Secondary Circuit Malfunction

Regarding the C1637 code, it would probably be worthwhile to carefully inspect the wire harness near the intake manifold bracket. This is done most easily from below the car in the area near the oil filter.

C1637 OBD-II Diagnostic Chassis (C) Trouble Code Description

C1637 engine trouble code is about Ignition Coil A Primary/Secondary Circuit Malfunction.

Main reason For C1637 Code

The reason of C1637 OBD-II Engine Trouble Code is Fuel Composition Sensor Circuit Malfunction.

C1637 DTC specifically refers to the camshaft (cam) timing. In this case, if the cam timing is over-retarded, the engine light will be illluminated and the code will be set.